Specifications

106 Chapter 7

Sorting DUTs Based on Measurement Results

Setting Up the Bin Sorting Function

Turning on/off the bin sorting function (comparator)

To enable or disable the bin sorting function (comparator), use the following command:

• :CALC:COMP on page 211

Setting the beep condition

You can configure the instrument to beep under one of the following two conditions:

• When a DUT has failed to pass the bin sorting criteria (i.e., sorted into a bad bin or not

sorted into any bin).

• When a DUT has passed the bin sorting criteria (i.e., sorted into a good bin).

To set the beep condition, use the following command:

• :CALC:COMP:BEEP:COND on page 211

You can also disable the beep function. To turn on or off the beep, use the following

command:

• :SYST:BEEP2:STAT on page 303

Setting the sorting conditions for each bin

You can define up to 4 sorting conditions for each bin. When two or more conditions are

specified, the instrument tests the DUT's characteristics to the AND of those conditions.

Resetting the sorting conditions

You can initialize the on/off setting, sorting conditions, and OUT_OF_GOOD_BINS line

setting for all bins by issuing the following command:

• :CALC:COMP:CLE on page 214

Enabling or disabling individual bins

You can enable or disable each bin separately. When a bin is disabled, the bin's sorting

conditions are ignored and no DUT is sorted into the bin. To enable or disable a single bin,

use the following command:

• :CALC:COMP:BIN{1-13} on page 212