Instruction manual

Chapter 4 91
Function Overview
Names and Functions of Display Areas on the LCD Display
4. Function Overview
Measurement point setup display
When no dialog box is shown, the measurement point setup display (Figure 4-7) can be
displayed by pressing the [Setup View] key the required number of times.
Figure 4-7 Measurement point setup display
1. Setup display menu bar
The following menus are available on the menu bar of the setup display (the menu bar is
shared by all four setup displays).
NOTE The menu bar operation is the same as that described in “2. Measurement display menu
bar” on page 84.
The menu items under each menu remain the same for all setup displays. However,
depending on the display, there are some menu functions that cannot be selected; in this
case, the name of the menu item is dimmed.
2. Measurement point setup tab
When the “STIMULUS” tab is displayed in front of the other three tabs, the screen shows
1. File Used for saving items in the setup table into the 4287A
mass storage and for printing.
2. Edit Used for editing the items in the setup table.
3. View Used for setting the display area of setup table.
4. Table Used for selecting the table number.