Instruction manual

Chapter 3 71
Learning Basic Operations
Display of DUT Connection and Measurement Result
3. Learning Basic
Operations
3-30).
Figure 3-30 Measurement parameter 1 changed to Ls
Measurement and display of all set measurement points
(list measurement)
In Figure 3-28 on page 69 and Figure 3-29 on page 70, only one of the set measurement
points is selected for measurement and display. However, measurement and display can
also be executed
at all of the set measurement points simultaneously by following this step.
Step 1. On the single point measurement display, press the [Meas View] key on the measurement
block (MEASUREMENT) of the front panel once to select the list measurement display
(
Figure 3-31).