Instruction manual

70 Chapter 3
Learning Basic Operations
Display of DUT Connection and Measurement Result
Step 5. Press the rotary knob ( ) to accept the selection of the measurement point number
(Figure 3-29).
Figure 3-29 Measurement point changed to measurement point number 4
How to change measurement parameters
Set which of the four measurement parameters is to appear on the display by following
these steps.
Step 1. Press the [Prmtr] key on the measurement block (MEASUREMENT) of the front panel.
The measurement parameter selection menu appear
s in the softkey area on the right side of
the display.
Step 2. Turn the rotary knob ( ) to move the cursor in the softkey menu to the SETUP MEAS
PRMTRS key.
Step 3. Press the rotary knob ( ) to display the SETUP MEAS PRMTRS softkey menu on the
right side of the display.
Step 4. Turn the rotary knob ( ) to move the cursor in the softkey menu to the softkey
corresponding to the measurement point number whose measurement parameters should be
changed (
PRMTR-1 [ ] in this case).
Step 5. Press the rotary knob ( ) to display the PRMTR-1 [ ] softkey menu on the right side of
the display.
Step 6. Turn the rotary knob ( ) to move the cursor in the softkey menu to the softkey
corresponding to the desired measurement parameter (Ls in this case).
Step 7. Press the rotary knob ( ) to accept the selection of the measurement parameter (Figure