Instruction manual

64 Chapter 3

Learning Basic Operations

Calibration and Compensation

Figure 3-20 How to retract connector sleeve of load standard

Step 3. While pressing the load standard (50 Ω) from above, turn the connector nut clockwise and

ecurely connect it to the 7-mm terminal (Figure 3-21).

Figure 3-21 How to connect load standard

Step 4. Press the key or key on the front panel the required number of times to move the

cursor to the Next> button.

Step 5. Press the key on the front panel to start measurement of load calibration data. The bar

in the Calibration progress indicator in the calibration window indicates the progress of the

load calibration data measurement. Upon completion of load calibration data measurement,

the screen changes to the next window (

Figure 3-22).