Instruction manual

Chapter 3 59
Learning Basic Operations
Calibration and Compensation
3. Learning Basic
Operations
Step 2. Press the rotary knob ( ) to display the calibration and compensation wizard welcome
window (Figure 3-10).
Figure 3-10 Calibration and compensation wizard welcome window
Step 3. Press the key or key on the front panel to select the Cal/Compen for a Fixture
Measurement option () (filled circle should appear inside the radio button).
Step 4. Press the key or key on the front panel the required number of times to move the
cursor to the Next> button.
Step 5. Press the key on the front panel. The window for setting up the test head and test
fixture stand (Figure 3-11) appears.
Figure 3-11 Display for setting up test head and test fixture stand
Step 6. Confirm that the setup has been performed as shown in Figure 3-2, “Connection between
test head and fixture stand,” on page 52 (in this condition nothing should be connected to
the 7-mm terminal).