Instruction manual

Chapter 2 35
Installation Guide
Preparation for Power Supply
2. Installation Guide
Preparation for Power Supply
Before turning on power to the equipment, be sure to verify the following:
Check the power supply
Check that the power supplied to the Agilent 4287A meets the following requirements:
Verification and connection of power cable
The three-wire power cable attached to the Agilent 4287A has one wire serving as a
ground. Use of this power cable allows the Agilent 4287A to be connected to ground,
thereby protecting you against electric shock via the power outlet.
Step 1. Check whether the power cable is damaged or not.
WARNING NEVER use a power cable showing any sign of damage. Faulty cables can cause
electric shock.
Step 2. Use the supplied cable to connect between the power terminal on the rear panel of the
Agilent 4287A and a three-wire power outlet with the grounding prong firmly connected in
the ground slot.
WARNING Use the attached three-wire power cable with grounding wire to securely ground the
Agilent 4287A.
Figure 2-17 shows the power cable options.
Requirements
Vo l t a g e
90 to 132 VAC or 198 to 264 VAC
*1
*1. Switched automatically by the Agilent 4287A in conformity to the voltage.
Frequency 47 to 63 Hz
Maximum power consumption 350 VA