Instruction manual

318 Appendix E
Printing Out Measurement Results and Internal Data on a Printer
Step 2. Press or on the front panel to highlight the desired printer model.
NOTE When you use the DeskJet 930C, select “HP DeskJet 970C Series”.
Step 3. Press on the front panel the required number of times to move the cursor to the OK
button.
Step 4. Press on the front panel to close the Available Printers dialog box.
NOTE To cancel the printer selection, move the cursor to the Cancel button in Step 3. Then press
to close the Available Printer dialog box. In this case, the printer selection remains
unchanged from the last time a selection was made.
5. Starting and stopping printing
Step 1. Check that the printer is properly connected to the printer parallel port on the rear panel of
the 4287A.
Step 2. Check that paper is properly loaded in the printer.
Step 3. Check that the printer is turned ON.
Step 4. Turn the rotary knob on the front panel to move the cursor in the softkey menu to
PRINT. Then press to start printing.
NOTE If you have selected CONTENT [SCREEN] as the item to be printed, save the image to
the clipboard before starting print.
When there is no saved image on the clipboard, the image at the start of print is printed.
Therefore, if you start print with the menu bar at the top of the screen using a mouse and
the like, the pull-down menu displayed for the operation may partly hide the image you
want to print. To avoid this, before starting print, press
[Display] (Capture is shown above
it) with the image you want displayed to save the image to the clipboard.
NOTE To stop printing after it has been started, turn the rotary knob on the front panel to
move the cursor in the softkey menu to ABORT PRINTING. Then press to stop
printing.