Instruction manual

316 Appendix E
Printing Out Measurement Results and Internal Data on a Printer
Procedure for Printing
Follow this procedure to print out the screen information on a printer.
1. Selecting the contents to be printed
Step 1. To print a screenshot of the information shown on the LCD display, display the screen that
you want to print.
Step 2. Press [Display] on the front panel (Capture is imprinted on the front panel above the key).
At this point, the displayed image data are copied to the clipboard (internal temporary
memory). At the same time, the Display softkey menu appears.
Step 3. Turn the rotary knob on the front panel to move the cursor in the softkey menu to
PRINT MENU. Then press to display the PRINT MENU softkey menu.
Step 4. Turn the rotary knob on the front panel to move the cursor in the softkey menu to
CONTENT [ ]. Then press to select the content to be printed (each press switches the
selection in order).
2. Setting the image format
If CONTENT [SCREEN] is selected in “1. Selecting the contents to be printed”, the image
format is set by following this procedure.
Step 1. Turn the rotary knob on the front panel to move the cursor in the softkey menu to
IMAGE [ ]. Then press to select the image format (each press switches the selection in
order).
Softkey Label Printed Content
CONTENT [SCREEN] Image copied to the clipboard.
CONTENT [SETUP] Contents (measurement point setup table,
calibration kit table, BIN sort setup table)
of the selected measurement point table
(active table).
CONTENT [LIST] List of the parameters for each
measurement point displayed on the list
measurement display.