Instruction manual

Appendix A 287

Manual Changes

A. Manual Changes

Now the system recovery of the 4287A is complete.

NOTE If the problem persists even after executing system recovery, the 4287A is at fault; contact

your local Agilent customer center listed at the end of this manual or the distributor from

which you purchased the instrument.

Change 5

“Configuring the network” can not be applied. Reffer to the following explation.

Checking and Editing the LAN Settings

The following explains how to set the necessary addresses and other settings required for

using the LAN (Local Area Network) functions of the 4287A. For details on LAN

functions, see the Programming Manual.

Checking and editing the network addresses

The 4287A network addresses (IP address, Gateway address, Sub Net Mask) can be

checked and edited by the following procedure (IP: Internet Protocol).

NOTE For how to perform the instruction “press the key (softkey) in the softkey menu”

mentioned in the procedure, see “13. Softkeys” on page 87.

Step 1. Press the [System] key on the front panel to display the System softkey menu.

Step 2. Press the LAN SETUP key in the softkey menu to display the LAN SETUP softkey menu.

Step 3. Press the SETUP IP ADDRESS key in the softkey menu to display the Network Address

Setup dialog box (

Figure A-2).

Figure A-2 Network Address Setup dialog box

Step 4. Perform the following operations to enter the IP address, Gateway address and Net Mask

address in their respective input boxes of the dialog box.

Function

Operation

Front panel Keyboard Mouse

Moving the cursor

Turn , or

press .

Press [Tab][↑][↓][←][→]. Click the position where the

cursor should be moved to.