Instruction manual

Chapter 12 253
Specifications and Supplemental Performance Characteristics
Basic Measurement Characteristics
12. Specifications and
Supplemental Performance
Characteristics
Basic Measurement Characteristics
Measurement parameters
Measurement range
Source characteristics
Frequency
Oscillator Level
Impedance parameters |Z|, |Y|, Ls, Lp, Cs, Cp, Rs, Rp, X, G, B, D, Q, θz [°],
θz
[rad], θy [°], θy [rad]
(A maximum of four parameters can be displayed at one
time.)
Measurement range 200 mΩ to 3 kΩ
Frequency = 1 MHz
Averaging factor = 8
Oscillator level ≥ −33 dBm
Measurement uncertainty ≤ ±10 %
Calibration is performed within 23 °C ±5 °C
Measurement is performed within ±5 °C of calibration
temperature)
Range 1 MHz to 3 GHz
Resolution 100 kHz
Uncertainty ±10 ppm (23 ±5°C)
±20 ppm (5°C to 40°C)
Range
Cable length: 1 m
Power (when 50 Ω LOAD is
connected to test port)
− 40 dBm to 1 dBm (Frequency ≤ 1 GHz)
− 40 dBm to 0 dBm (Frequency > 1GHz
*1
)
Current (when SHORT is
connected to test port)
0.0894 mArms to 10 mArms (Frequency ≤ 1 GHz)
0.0894 mArms to 8.94 mArms (Frequency > 1 GHz
*1
)
Voltage (when OPEN is
connected to test port)
4.47 mVrms to 502 mVrms (Frequency ≤ 1 GHz)
4.47 mVrms to 447 mVrms (Frequency > 1 GHz
*1
)
Cable length: 2 m (when Option 002 is used)
Power Subtract the following attenuation from the power (setting
value) at 1 m cable length:
Attenuation [dB] = 0.37 ×
(F: Frequency [GHz])
F