Instruction manual

Chapter 11 233
Setting and Using the Control and Management Facilities
Setting the Built-in Speaker (Beep Sound)
11. Setting and Using the Control and Management
Facilities
Setting the Built-in Speaker (Beep Sound)
The 4287A is provided with a built-in speaker for emitting beep sounds. The beep sounds
serve two functions as shown in
Table 11-1.
Turning the completion beep ON or OFF
The following procedure is used to turn the completion beep ON or OFF.
NOTE For how to perform the instruction “press the key (softkey) in the softkey menu”
mentioned in the procedure, see “13. Softkeys” on page 87.
Step 1. Press the [System] key on the front panel to display the System softkey menu.
Step 2. Press the BEEPER MENU key in the softkey menu to display the BEEPER MENU softkey
menu.
Step 3. Press the BEEP DONE [ ] key in the softkey menu to turn the completion beep ON or OFF
(the setting toggles with each press of the button).
NOTE Pressing the PLAY BEEP DONE key in the BEEPER MENU softkey menu allows you to
hear the completion beep to test its operation.
Turning the warning beep ON or OFF
The following procedure is used to turn the warning beep ON or OFF.
NOTE For how to perform the instruction “press the key (softkey) in the softkey menu”
mentioned in the procedure, see “13. Softkeys” on page 87.
Step 1. Press the [System] key on the front panel to display the System softkey menu.
Table 11-1 4287A beep functions
Type Function
Completion beep Beep sound heard when saving of calibration data or
measurement data is completed.
Warning beep Beep sound heard when a warning message is
displayed or when the result of the BIN sort function
(comparator) is “pass” or “fail.”
Softkey Label Completion Beep Setting
BEEP DONE [ON] ON
BEEP DONE [OFF] OFF