Instruction manual

192 Chapter 8

Sorting According to Measurement Results

Example of Settings for BIN Sorting

The following introduces an example of setting an actual BIN sort setting table. The

sorting conditions to be set are shown in

Table 8-2.

NOTE When both Condition 1 and Condition 2 of Table 8-2 are met, the DUT is placed in the

appropriate BIN.

In Table 8-2, “” denotes that this point is included, and “” denotes that this point is not

included.

Perform the following steps to set these conditions in the 4287A.

Table 8-2 Sorting conditions

BIN Condition 1 Condition 2

Measurement point number: 3 (100 MHz)

Measurement parameter: Ls

Measurement point number: 3 (100 MHz)

Measurement parameter: Q

BIN 1

BIN 2

BIN 3

OUT OF

BINS