Instruction manual

190 Chapter 8

Sorting According to Measurement Results

Bin Count Function

Effective from

Firmware Rev. 1.20

The Bin Count function counts the frequency by incrementing the bin count corresponding

to the Bin Sorting result by 1 each time measurement ends. The frequency of each bin can

be viewed on the display when necessary.

Turning on Bin Count

If Bin Count is turned on, the bin frequency corresponding to the result is incremented by 1

each time Bin Sorting is run by measurement.

Bin Count can be turned on using the following procedure:

Step 1. In the front panel Measurement Block, press the [Prmtr] key to display the Prmtrs softkey

menu.

Step 2. In the softkey menu, press the BIN COUNT MENU to display the BIN COUNT MENU

softkey menu.

Step 3. In the softkey menu, press the COUNT [ ] key to turn on Bin Count.

NOTE Even when Bin Count is turned on, the counter value is unchanged unless Bin Sorting is

actually run. For using the Bin Sorting function, refer to Chapter 8, "Sorting According to

Measurement Results" in the Operation Manual.

Listing the BIN Count results

The Bin Count results can be listed on the LCD display by using the following procedure:

Step 1. In the front panel Measurement Block, press the [Prmtr] key to display the Prmtrs softkey

menu.

Step 2. In the softkey menu, press the BIN COUNT MENU to display the BIN COUNT MENU

softkey menu.

Step 3. In the softkey menu, press the DISPLAY key to list the BIN Count results (see Figure 8-16).

softkey label Status of Bin Count

COUNT[ON] On

COUNT[OFF] Off