Instruction manual

184 Chapter 8
Sorting According to Measurement Results
Setting BIN Range
Setting lower limit value
Follow these steps to set the lower limit value after setting the upper limit value of the BIN
as follows:
Step 1. Click with the mouse in the cell corresponding to the column of the desired sorting
condition (one of conditions 1 to 4) on the row of the lower limit value of the BIN to be set.
Step 2. Press the entry block numeric keys ([0] to [9][-][.]) to enter the lower limit value of the BIN
to be set and then press the desired unit key (
[G/n], [M/μ], [k/m], or [×1]).
To set the lower limit value to 49 nH when the limit mode is in absolute mode, for example,
press
[4], [9], and then [G/n].
To set the lower limit value to -1% of the reference value (Nominal) when the limit mode is
in percentage mode, press
[-] and [1] and then [×1] (Figure 8-10).
Figure 8-10 Setting lower limit value of BIN 1