Instruction manual

Chapter 8 179
Sorting According to Measurement Results
Setting Measurement Parameter
8. Sorting According to Measurement Results
Setting Measurement Parameter
After setting the measurement point number, select the measurement parameter for BIN
sorting.
NOTE Similar to setting the measurement point, selecting the measurement parameter in BIN
sorting is independent of the selection of the measurement parameter in the measurement
display (single point measurement or list measurement).
Step 1. Click with the mouse in the measurement parameter cell in the sorting condition to be set
(one of conditions 1 to 4).
Step 2. Click the down arrow () at the right edge of the cell.
Step 3. Click the desired measurement parameter from the drop-down list box to select it (Figure
8-6).
NOTE Click on  in the upper-right or  in the lower-right part of the list box or use the scroll
thumb to scroll the list.
BIN sort measurement parameter Definition
Ls Equivalent series inductance
Lp Equivalent parallel inductance
Cs Equivalent series capacitance
Cp Equivalent parallel capacitance
Rs Equivalent series resistance
Rp Equivalent parallel resistance
Q Quality factor
D Dissipation factor
G Equivalent parallel conductance
B Equivalent parallel susceptance
X Equivalent series reactance
|Z| Absolute value of impedance
|Y| Absolute value of admittance
θz (rad) Impedance phase (radian)
θz (deg) Impedance phase (deg.)
θy (rad) Admittance phase (radian)
θy (deg) Admittance phase (deg.)