Instruction manual

Chapter 7 165
Executing Measurements and Displaying Results
Setting How the Instrument Displays Measurement Results
(Enabling/Disabling Deviation Measurement Mode)
7. Executing Measurements
and Displaying Results
Follow these steps to set the deviation measurement mode.
Step 1. Press the [Prmtr] key in the measurement block to display the parameter setup softkey
menu in the list measurement display.
Step 2. Select the SETUP DEVIATION key from the softkey menu to display the deviation setup
softkey menu.
Step 3. Select the desired parameter label (PRMTR-1 [ ] to PRMTR-4 [ ]) from the softkey menu,
and the deviation setup softkey menu for the selected label will appear.
Step 4. Press the DEV MODE key in the softkey menu to select the mode (the setting toggles with
each press of the button).
Step 5. Press the CENTER key in the softkey menu, and enter the reference value when you select
Deviation or % Dev..
Softkey Label Deviation measurement mode
DEV MODE [OFF] OFF
DEV MODE [Deviation] ON (absolute deviation mode)
DEV MODE [% Dev.] ON (percent deviation mode)