Instruction manual

162 Chapter 7
Executing Measurements and Displaying Results
Selection of Display Parameters in List Measurement Display
Selection of Display Parameters in List Measurement
Display
In the list measurement display, a maximum of four parameters can be simultaneously
displayed for the listed measurement points. Follow these steps to set the list display
parameters.
Step 1. Press the [Prmtr] key in the measurement block to display the parameter setup softkey
menu in the list measurement display.
Step 2. Select the SETUP LIST PRMTRS key from the softkey menu to display the list display
parameter setup softkey menu.
Step 3. Select the desired list display label (LABEL-1 [ ] to LABEL-4 [ ]) from the softkey menu,
and the display parameter selection softkey menu for the selected label will appear.
Step 4. Select the desired display parameter from the softkey menu.
NOTE Instead of performing the key operation [Prmtr] - SETUP LIST PRMTRS - LABEL-1 [ ] to
LABEL-4 [ ] as described above, you can directly click on a list display parameter’s column
heading (
“2 to 5. Labels 1 to 4” on page 89) on the display; this immediately displays the
selected label’s parameter selection softkey menu.
Softkey label List display parameter
PRMTR-1
*1
*1. The four measurement parameters set to show up on the single point measurement dis-
play are indicated as softkey labels in brackets.
The measurement parameter set as measurement
parameter 1
PRMTR-2
*1
The measurement parameter set as measurement
parameter 2
PRMTR-3
*1
The measurement parameter set as measurement
parameter 3
PRMTR-4
*1
The measurement parameter set as measurement
parameter 4
V-mon Test signal voltage level monitor value
I-mon Test signal current level monitor value
FREQ Measurement frequency
AV G Averaging factor
POWER Test signal level (power)
R_dc DC resistance measurement value