Instruction manual

160 Chapter 7
Executing Measurements and Displaying Results
Selection of Measurement Parameters in Single Point Measurement Display
Selection of Measurement Parameters in Single Point
Measurement Display
In the single point measurement display, a maximum of four parameters can be
simultaneously displayed for the selected measurement point. Follow these steps to set the
measurement parameters.
Step 1. Press the [Prmtr] key of the measurement block to display the Prmtrs softkey menu.
Step 2. Select the SETUP MEAS PRMTRS key from the softkey menu to display the SETUP
MEAS PRMTRS softkey menu.
Step 3. Select the desired measurement parameter number from the softkey menu (PRMTR-1 [ ] to
PRMTR-4 [ ]), and the measurement parameter selection softkey menu for the selected
measurement parameter number will appear.
Step 4. Select the desired measurement parameter from the softkey menu.
NOTE Instead of performing the key operation [Prmtr] - SETUP MEAS PRMTRS - PRMTR-1 to
PRMTR-4 described above, it is also possible to display the measurement parameter
Softkey label Measurement parameter
|Z| Absolute value of impedance
|Y| Absolute value of admittance
Ls Equivalent series inductance
Lp Equivalent parallel inductance
Cs Equivalent series capacitance
Cp Equivalent parallel capacitance
R Equivalent series resistance
Rs Equivalent series resistance
Rp Equivalent parallel resistance
Q Quality factor
D Dissipation factor
X Equivalent series reactance
G Equivalent parallel conductance
B Equivalent parallel susceptance
θz (rad) Impedance phase (radian)
θz (deg) Impedance phase (deg.)
θy (rad) Admittance phase (radian)
θy (deg) Admittance phase (deg.)