Instruction manual

158 Chapter 7

Executing Measurements and Displaying Results

How to Select the Measurement Point Table

Follow these steps to select the measurement point table according to “How to Set the

Measurement Point” on page 103.

Step 1. Press the [Stml Select] key on the front panel to display the Stml Select softkey menu.

Step 2. Select TABLE No. [ ] from the softkey menu to display the table number selection softkey

menu.

Step 3. Select the desired measurement point table from Tables 1 to 8 in the softkey menu.

NOTE Instead of performing the key operation [Stim Select] - TABLE No. [ ] as described above,

you can use the mouse to click the table number area (

“3. Table number” on page 85) in the

upper-left corner of the screen to display the table number selection softkey menu.