Instruction manual

Chapter 5 111
Setting Measurement Conditions
How to Set the Measurement Point
5. Setting Measurement
Conditions
How to change oscillator level setup unit
Change the oscillator level setup unit by following these steps:
Step 1. Click the mouse in the “Power” column heading to display the menu of the drop-down list
box.
NOTE The drop-down list box menu can also be displayed by using the mouse to click the
down-arrow  to the right of the Power cell.
Step 2. Click on a new unit name from the drop-down list box menu (Figure 5-9).
Figure 5-9 How to change oscillator level setup unit
As a result, the signal level unit of each measurement point is converted to the selected unit
(
Figure 5-10).