Instruction manual

11 0 Chapter 5
Setting Measurement Conditions
How to Set the Measurement Point
How to change oscillator level
Change the oscillator level of an already set measurement point by following these steps:
Step 1. Use the mouse to select the oscillator level cell at the measurement point you want to
change.
Step 2. Enter a new oscillator level by pressing the numeric entry keys of the entry block ([0] to
[9], [-] and [.] and [×1] sequentially.
To set the oscillator level to -10 dBm, for example, press [-], [1] and [0] (Figure 5-8) and
then [×1].
Figure 5-8 How to change oscillator level