Instruction manual

Chapter 5 109
Setting Measurement Conditions
How to Set the Measurement Point
5. Setting Measurement
Conditions
How to change averaging factor
Change the averaging factor of an already set measurement point by following these steps:
Step 1. Use the mouse to select the averaging factor cell at the measurement point you want to
change.
Step 2. Enter a new averaging factor by pressing the numeric entry keys of the entry block ([0] to
[9]) and [×1]) sequentially.
To set the averaging factor to “10,” for example, press [1] and [0] (Figure 5-7)and then [×1].
Figure 5-7 How to change the averaging factor