Technical data

142 4000 X-Series Oscilloscopes Advanced Training Guide
4 Serial Bus Decoding & Triggering, Search & Navigation, and Segmented Acquisition Labs
13 Set the scope timebase to 2.000 ms/div.
14 Press the [Search] feature in the Horizontal area of the front panel.
15 You will notice a display pop up telling you to enable the Lister feature
in order to search. Do this by tapping the double down arrows in the
top right corner of the waveform display, which brings up a half screen
Lister window. This is a list of all decoded words and errors.
16 Ensure that Search for is set to Label, and then tap the Label softkey. Use
the Entry knob to set a value of 076.
White arrows should appear on the top of the waveform, below the Lister
window. These represent the locations of all hits from the search
parameters, namely all words with a label of 076. There should be 10- 11
on the display. They are also marked in the Lister window with orange
tabs on the left column.
17 Press [Run/Stop] to halt all acquisitions.
18 Use the and front panel navigation keys to automatically scroll
through all search results. The lower screen will automatically zoom
into the word in the search list, and point to it in the lister window.
See Figure 97.
Figure 96 Triggering on a frame with label 076.