Technical data

12 4000 X-Series Oscilloscopes Advanced Training Guide
2 Oscilloscope Familiarization Labs
Lab #1: Using Cursors and Automatic Parametric Measurements
During this first hands- on lab, you will learn how to make simple voltage
and timing measurements using the scope’s manually positioned
measurement cursors, as well as perform similar measurements using the
scope’s automatic parametric measurement capability.
1 Connect the channel-1 probe to the Demo 1 terminal and ground.
2 Press [Default Setup] on the scope’s front panel.
3 Press [Help]; then press the Training Signals softkey.
4 Using the touch screen Training Signals menu, select the Repetitive Pulse
with Ringing signal; press the Output softkey to turn it on.
5 Set channel- 1’s V/div setting to 500 mV/div.
6 Set channel- 1’s position/offset to 1.40 V.
7 Push the trigger level knob to automatically set the trigger level at
approximately 50%.
8 Set the scope’s timebase to 500.0 ns/div.
Figure 1 Oscilloscope setup to capture and display a repetitive digital pulse with ringing
and overshoot.