User`s guide

BACKUP Menu:
Backup: Go Source Dest Length Errors Log Help Quit
Hot Keys: GS DLEOHQ
Go Start the backup. If the source and destination disks are the same, then you will be
prompted to swap source/dest disks. During the backup, the PROGRESS window
shows how much of the backup operation has been completed. A backup may be
aborted at any time by pressing the ‘’ESC’’ key.
Source Specify the external (e.g. 102:) or internal (e.g. b:) source LIF disk. The source
disk should be write protected to prevent accidental erasure of data in the event that
the disk is placed in the wrong drive.
Dest Specify the external (e.g. 102:) or internal (e.g. b:) destination LIF disk. The
destination disk must be writeable and already formatted. The destination disk must
be large enough to contain the contents of the source disk. A warning will be
displayed if the destination is too small for full disk copy.
Length Specify whether the entire source disk (Full disk) will be copied or only the area of
the disk containing up to the last LIF file. Full disk should be specified if the
LIF directory has been damaged.
Errors Specify whether a read/write error will cause the backup to Stop or whether the
error is Ignored (the sector is cleared on the destination disk). Any errors are
displayed in the ERRORS window.
Log Specifies a log file where the same errors that are shown in the ERRORS window
will be appended to. For example, ‘’prn’’ specifies the printer. Note: the log file
must be specified before starting the backup.
Help Display command summary on the display.
Quit Quit backup function.
File System Conversion (LIF/DOS)
LIFDIAG
3-23