User`s guide

Format menu
File: Auto Single Upper/Lowe
r
Up/Mid/Low Front/Back Overlay Waterfall A_vs_B Help
Hot Keys: AS U M F O W V H
Auto Determine the format from the data in the traces. If only one trace has data and it is
the active trace, the format is single for single-scan data or waterfall for multi-scan
data. If two traces have data, the format is upper/lower. If all three traces have
data, the format is up/mid/low.
Single Display one trace (the active trace).
Upper/Lower Display two traces (A on top, B on the bottom).
Up/Mid/Low Display three traces (A on top, B in the middle, and C on the bottom).
Front/Back Display the A and B traces overlayed in the same grid area.
Overlay Display the A, B, and C traces overlayed in the same grid area.
Waterfall Display all scans of a multi-scan trace in a partially-overlapped form in a single grid
area. To set the amount of overlap, use WfallHeight under Display, Yscale. To set
the active scan, use Scan under Display, Active.
A_vs_B Show Trace A Y-data vs. Trace B Y-data (on X-axis). Each trace’s Y-data values
are determined by the Coordinate and Yscale set in the respective active trace (e.g.
can display Phase of Trace A vs. Imaginary part of Trace B). The number of
display points is determined by Trace A. If Trace B has fewer points, then the last
Y-data value is repeated. If Trace B has no data, then all of it’s Y-data values are
0.0.
Help Display help information.
Viewdata
5-13