Programming instructions

Front-Panel Operation 57
To Reset a Module
To reset a plug-in module:
1. Turn the knob to select the slot to be reset;
2. Hold down Card Reset until the display changes from “HOLD TO
RESET” to “RESET CARD”, then release the key to end this
operation.
Note Card Reset will open all channels on the switching module and make all
ports on the specific digital I/O module as input ports.
To Reset the Instrument
To reset the instrument:
1. Press Shift, then hold down Card Reset, the display would be:
2. Hold the key until the display message changes, then release the key;
3. When the instrument finishes resetting, the default display appears.
Note The instrument will also be reset if any plug-in module is installed or
removed while the instrument is on.
N2260A 1
HOLD TO RESET 1
RESET CARD 1
N2260A 1
HOLD TO RESET
RESET. . .
MUX 101OPEN