Programming instructions

52 Front-Panel Operation
3. Press Menu again to exit this operation, the CONFIG annunciator
turns off accordingly.
Note Please note that the content in this section is only effective for Agilent
3499A/B/C mainframe with Firmware REV 4.0 or later. for Agilent
3499A/B with Firmware REV1.0/2.0/3.0, please ignore this section.
Note If the power-on state of the instrument is set to a previously stored setup
that is no longer valid, the power-on state will automatically set to the reset
state, in this case the instrument displays “RECALL FAILED”.