Programming instructions

46 Front-Panel Operation
value (ranging from 0 to 99999.999 seconds);
3. Use the arrow keys and the knob to set the arm source, press Enter;
4. Turn the knob to set the trigger source, then press Enter to return to
“CONFIG TO SCAN”;
If “TRIG:TIMER” is specified, the instrument will guide you to set
the time interval (default is 0) after pressing Enter. Use the two arrow
keys and the knob to edit or modify the value. Press Enter to set this
value (ranging from 0 to 99999.999 seconds) and return to “CONFIG
TO SCAN”;
5. Press S.List again to exit this operation, the CONFIG annunciator
turns off accordingly.
To Set a Delay Time 1. Press S.List, the CONFIG annunciator lights up. Turn the knob until
“DELAY TIME” is displayed, press Enter;
2. To set a uniform delay time for all channels, select “SET ALL”, then
press Enter. Use the arrow keys and the knob to modify the value
(between 0 and 99999.999 seconds). Press Enter to set the delay time
and return to “DELAY TIME”;
3. To set a different delay time for individual channel, select “SET CH”,
then press Enter. Turn the knob to select the channel to be set (i.e.
103), then press Enter again and use the arrow keys and the knob to
00002.000 SECS
COUNT: 00003
TRIG: MIX
00000.200 SECS
DELAY TIME
SET ALL
00000.002 SECS
DELAY TIME