Programming instructions

40 Front-Panel Operation
To View the Relay
Cycles
To view the relay cycle counts:
1. Press View, the VIEW annunciator lights up. Turn the knob until
“RELAY CYCLES” is displayed, then press Enter;
2. If no module with the relay cycle count feature
[1]
is present, “N/A”
will be displayed, then the display automatically returns to the first
level of the View menu;
If the selected channel is a relay without the cycle counts feature, the
instrument will display the cycle counts of the first relay with the feature;
If the selected channel (i.e. 109) is a relay with the cycle counts
feature, the cycle counts of the relay will be displayed;
3. Turn the knob to read other relays cycle counts, or press Enter to
return to the first level of the View menu;
4. Press View again to exit the View menu operation, the VIEW
annunciator turns off.
Mode Key Operation
A digital I/O and the digital I/O ports can be configured from the instrument
front panel. In SCPI mode, Agilent N2260A can be configured as different
MUX modules. The Mode key is designed for these configurations.
• Agilent N2260A can be configured in SCPI mode. Table 3-5 shows the
Mode key structure in this case.
[1]. Relay cycle count feature is supported by the switching relays on the Agilent N2260A/61A/62A/64A/65A modules.
RELAY CYCLES 400
N/A 400
7383 100
10132 109
RELAY CYCLES 108