Programming instructions

240 Index
instrument
firmware revision, 55
local/remote state, 34
mounting onto rack, 24
power on failure, 22
power on process, 22
power-on state setting, 52
serial number, 55
state storage, 37
system mode selection, 54
interface, GPIB (IEEE 488)
address selection, 53
enable/disable SRQ, 53
interface selection, 53
interface, RS-232
baud rate, 53
data bits, 54
flow control, 54
parity, 54
K
keyboard
pictorial overview, 32
M
maintenance
read relay count, 40
Menu key operation
configure external trigger, 50
configure power-on state, 52
configure remote interface, 53
firmware revision query, 55
perform self-test, 54
serial number query, 55
system mode setting, 54
Menu key structure
in 3488A mode, 48
in SCPI mode, 49
modules
crimp-and-insert terminal block, 116
DIN-to-D cables, 119
installation, 22
removal, 23
screw terminal blocks, 110
monitoring channel/slot, 34
mount 3499A, 28
mount 3499B, 29
mount 3499C, 30
mount mainframe onto rack, 24
N
N2297A DIN-to-D cable diagram, 119
N2298A DIN-to-D cable diagram, 120
N2299A DIN-to-D cable diagram, 121
O
open/close relay channel, 36
P
plug-in modules
crimp-and-insert terminal block, 116
DIN-to-D cables, 119
installation, 22
removal, 23
screw terminal blocks, 110
power on instrument, 22
power-on SRQ, 53
power-on state setting, 52
R
read from port, 36
read relay cycles, 40
rear panel connectors, 2
recall instrument state
by directly recalling, 38
by setting power-on to, 52
remote interface configuration, 53
remote interface, GPIB (IEEE 488)
address selection, 53
enable/disable SRQ, 53
interface selection, 53
remote interface, RS-232
baud rate, 53
data bits, 54
flow control, 54
parity, 54
remove module from mainframe, 23
reset instrument, 57
RS-232 interface
baud rate, 53
data bits, 54
flow control, 54
parity, 54
selecting interface, 53