Technical data

34980A Getting Started Guide 13
10. Press the Channel key in
the
Measure key group.
Note that the Channel key
lights, the required relays
automatically close, and
dc voltage measurements
begin.
11. To stop the continuous
measurements, press the
Channel key again. Note that
as you press the Channel
key, you will hear the relays
automatically opening.
12. Using steps 1 through 6 on
the previous page, set the
following configuration for
Channel 1014. For this
example, don’t change any
other measurement
parameters.
• Channel 1014
• AC VOLTS function
• 1V range
13. Press the EXIT MENU key to
accept the new settings and
retain all other parameters in
this menu.
14. With Channel 1014 selected,
press the Channel key in the
Measure key group.
The Channel key lights,
the required relays
automatically close,
and measurements begin.
15. With the Channel key still
lighted, turn the knob to
display channel 1016.
You should see
measurements start for
DC VOLTS (your previously
configured function for
channel 16).
Continued on next page…
10
10
14