User`s guide

78
Chapter 3 System Overview
Measurement Input
You can configure the event or action that controls the onset of each
sweep through the scan list (a sweep is one pass through the scan list):
• You can set the instrument’s internal timer to automatically scan at a
specific interval as shown below. You can also program a time delay
between channels in the scan list.
• You can manually control a scan by repeatedly pressing from the
front panel.
• You can start a scan by sending a software command from the remote
interface.
• You can start a scan when an external TTL trigger pulse is received.
• You can start a scan when an alarm condition is logged on the
channel being monitored.
Scan List (1 sweep)
Scan-to-Scan interval
(0 to 99:59:59 hours)
Scan Count
1 to 50,000 scans, or continuous)
t
34970A Refresh UG.book Page 78 Wednesday, February 17, 2010 12:34 PM