User`s guide

232
Chapter 5 Error Messages
Instrument Errors
459 Logging to USB was stopped
Data logging was stopped prior to completion due to an abort or some
other error condition.
460 Logging to USB was stopped after 2^32 sweeps of data
Instrument is only able to capture 2^32 (~4.3 billion) sweeps worth of
data on an external USB drive
461 Memory lost: non-volatile settings; USB drive
Data in non-volatile memory was lost or corrupted. USB logging enable,
row limit and column separator will be set to defaults.
462 Configuration import aborted
Reconfiguration of the instrument was aborted.
463 Configuration import failed
This is a summary error that will be generated if ANY other errors were
reported during configuration import.
464 Invalid import file
The instrument did not recognize the USB configuration import file.
465 Import file cardset does not match instrument
The current instrument configuration does not match the cardset
expected by the USB import file.
466 Operation not allowed in a configuration import file
An illegal command was used inside the USB import file.
467 No readings to export
Reading memory is empty; nothing was exported to the USB drive.
468 Unable to fetch measurement config from internal processor
The instrument was unable to fetch measurement configuration data
from the secondary processor due to a communications error.
469 Internal processor returned an invalid measurement config
Configuration data returned by secondary processor was bad.
Measurement configuration could not be determined.
34970A Refresh UG.book Page 232 Wednesday, February 17, 2010 12:34 PM