User`s guide

199
Chapter 4 Features and Functions
Multiplexer Module Default Settings
4
Multiplexer Module Default Settings
The table below shows the default settings for each measurement
function on the multiplexer modules. When you configure a channel for a
particular function, these are the default settings.
Temperature Measurements
Temperature Units
Integration Time
Display Resolution
Thermocouple Type
Open T/C Detection
Reference Junction Source
RTD Type
RTD Reference Resistance
Thermistor Type
Channel Delay
Default Setting
°C
1 PLC
0.1°C
Type J
Off
Internal
= 0.00385
R
o
= 100
5 k
Automatic Delay
Voltage Measurements
Range
Resolution
Integration Time
Input Resistance
AC Low Frequency Filter
Channel Delay
Default Setting
Autorange
5½ digits
1 PLC
10 M (fixed for all DCV ranges)
20 Hz (medium)
Automatic Delay
Resistance Measurements
Range
Resolution
Integration Time
Offset Compensation
Channel Delay
Default Setting
Autorange
5½ digits
1 PLC
Off
Automatic Delay
Frequency/Period Measurements
Range
Resolution
AC Low Frequency Filter
Channel Delay
Default Setting
Autorange
5½ digits (frequency), 6½ digits (period)
20 Hz (medium)
Automatic Delay
Current Measurements
Range
Resolution
Integration Time
AC Low Frequency Filter
Channel Delay
Default Setting
Autorange
5½ digits
1 PLC
20 Hz (medium)
Automatic Delay
34970A Refresh UG.book Page 199 Wednesday, February 17, 2010 12:34 PM