User`s guide
198
Chapter 4 Features and Functions
Instrument Preset State
Instrument Preset State
The table below shows the state of the instrument after a PRESET from
the Sto/Rcl menu or SYSTem:PRESet command from the remote
interface.
Measurement Configuration
Function
Range
Resolution
Advanced Settings
Total izer R e se t Mode
Totalizer Edge Detect
Instrument Preset State
No Change
No Change
No Change
No Change
Count Not Reset When Read
Rising Edge
Scanning Operation
Scan List
Reading Memory
Min, Max, and Average
Scan Interval Source
Scan Interval
Scan Count
Scan Reading Format
Monitor in Progress
Instrument Preset State
No Change
All Readings are Cleared
No Change
No Change
No Change
No Change
No Change
Stopped
Mx+B Scaling
Gain Factor (“M”)
Scale Factor (“B”)
Scale Label
Instrument Preset State
No Change
No Change
No Change
Alarm Limits
Alarm Queue
Alarm State
HI and LO Alarm Limits
Alarm Output Configuration
Alarm Output State
Alarm Output Slope
Instrument Preset State
No Change
No Change
No Change
No Change
Output Lines are Cleared
No Change
Module Hardware
34901A, 34902A, 34908A
34903A, 34904A
34905A, 34906A
34907A
Instrument Preset State
All Channels Open
All Channels Open
Channels s11 and s21 Selected
Both DIO Ports = Input, Totalizer Count =
0, Both DACs = 0 VDC
System-Related Operations
Display State
Error Queue
Stored States
Instrument Preset State
No Change
Errors Not Cleared
No Change
34970A Refresh UG.book Page 198 Wednesday, February 17, 2010 12:34 PM