User`s guide

197
Chapter 4 Features and Functions
Factory Reset State
4
Factory Reset State
The table below shows the state of the instrument after a
FACTORY RESET from the Sto/Rcl menu or *RST command from the
remote interface.
Measurement Configuration
Function
Range
Resolution
Integration Time
Input Resistance
Channel Delay
Total izer R e se t Mode
Totalizer Edge Detect
Factory Reset State
DC Volts
Autorange
5½ digits
1 PLC
10 M (fixed for all DCV ranges)
Automatic Delay
Count Not Reset When Read
Rising Edge
Scanning Operation
Scan List
Reading Memory
Min, Max, and Average
Scan Trigger Source
Scan Interval (used with
TRIGger:SOURce TIMer)
Scan Count
Scan Reading Format
Monitor in Progress
Factory Reset State
Empty
All Readings are Cleared
Not Changed
Immediate
10 Seconds
1
Reading Only (No Units, Channel, Time)
Stopped
Mx+B Scaling
Gain Factor (“M”)
Scale Factor (“B”)
Scale Label
Factory Reset State
1
0
VDC
Alarm Limits
Alarm Queue
Alarm State
HI and LO Alarm Limits
Alarm Output
Alarm Output Configuration
Alarm Output State
Alarm Output Slope
Factory Reset State
Not Cleared
Off
0
Alarm 1
Latched Mode
Output Lines are Cleared
Fail = Low
Module Hardware
34901A, 34902A, 34908A
34903A, 34904A
34905A, 34906A
34907A
Factory Reset State
All Channels Open
All Channels Open
Channels s11 and s21 Selected
Both DIO Ports = Input,
Totalizer Count = 0, Both DACs = 0 VDC
System-Related Operations
Display State
Error Queue
Stored States
Factory Reset State
On
Errors Not Cleared
No Change
34970A Refresh UG.book Page 197 Wednesday, February 17, 2010 12:34 PM