User`s guide

189
Chapter 4 Features and Functions
Remote Interface Configuration - 34972A
4
Resetting the LAN
You can reset the instrument's LAN settings to their default values.
• Front-Panel Operation:
RESET LAN: NO/YES
Enabling and Disabling DHCP
You can enable or disable Dynamic Host Configuration Protocol (DHCP).
When DHCP is enabled (factory setting), the instrument will try to
obtain an IP address from a DHCP server. If a DHCP server is found, it
will assign a dynamic IP address, Subnet Mask, and Default Gateway to
the instrument.
If a DHCP server is not found, the instrument uses AutoIP to
automatically configure its IPsetting in the Automatic Private IP
Addressing range (169.254.xxx.xxx).
When DHCP is disabled, the instrument will use the static IP address,
Subnet Mask, Default Gateway and DNS Server during power-on.
• Front-Panel Operation:
DHCP ENABLED/DISABLED
34970A Refresh UG.book Page 189 Wednesday, February 17, 2010 12:34 PM