User`s guide

Contents
17
Contents
Chapter 1 Quick Start
To Prepare the Instrument for Use 23
BenchLink Data Logger Software 25
To Connect Wiring to a Module 27
To Set the Time and Date 29
To Configure a Channel for Scanning 30
To Copy a Channel Configuration 32
To Close a Channel 33
If the Instrument Does Not Turn On 34
To Adjust the Carrying Handle 36
To Rack Mount the Instrument 37
Chapter 2 Front-Panel Overview
Front-Panel Menu Reference 41
To Monitor a Single Channel 44
To Set a Scan Interval 45
To Apply Mx+B Scaling to Measurements 46
To Configure Alarm Limits 47
To Read a Digital Input Port 49
To Write to a Digital Output Port 50
To Read the Totalizer Count 51
To Output a DC Voltage 52
To Configure the Remote Interface - 34970A 53
To Configure the Remote Interface - 34972A 55
To Store the Instrument State 57
Chapter 3 System Overview
Data Acquisition System Overview 60
Signal Routing and Switching 70
Measurement Input 74
Control Output 83
34970A Refresh UG.book Page 17 Wednesday, February 17, 2010 12:34 PM