User`s manual

71
Chapter 3 System Overview
Factory Default and Reset States
4
3
Factory Default and Reset States
The table on the next page shows the settings of the instrument after a
reset.
•You can reset the instrument either by pressing
Shift + Card Reset on the front-panel, or with a RESET command
over the remote interface.
•If a module is accidentally removed or installed while the
instrument power is on, the instrument will preform a reset.
3488 Mode Defaults
a. Current setting includes the selection of the GPIB interface and its address setting.
b. RS-232 interface CANNOT be used in 3488A mode.
Item Factory Default Reset
Interface GPIB/488 GPIB (Address 9) Keep current setting
a
RS-232
b
Keep current setting
System Mode SCPI Mode SCPI Mode Keep current setting
3488A Mode Keep current setting
System-Related Display State On On
Stored State Empty Keep current setting
Error Queue Empty Cleared
Module-Related Switching Channels Open Open
Digital I/O Ports Input Input
Card Pair None None
Scan-Related Scanning None Stop scan in progress
Scan List Empty Empty
Channel Delay
(seconds)
00
Trigger Out Pulse Disabled Disabled