User`s manual

125

Chapter 5 Remote Interface Reference

3488 Mode Commands

RECALL <1-40>

Recalls the channel/bit setup stored by the command STORE. Only relays

and static Digital Outputs are recalled. This means that only those

channels/bits that are closed in the stored channel setup will be closed

when the channel setup is recalled.

Note If no state has been stored in the channel setup selected, an error will

result and the 3499A/B/C will send SRQ if it was enabled (see MASK on

page 122). In this case, the 3499A/B/C remains in its previous state.

OUTPUT 709; “CLOSE 103,104,202,204,206; STORE 6”

OUTPUT 709; “RECALL 6”

RESET

Used to reset the 3499A/B/C to the power on state. Reset performs the

following:

• Identifies all plug-in modules and resets them (all relays open)

• Sets all parameters of the instrument to their default conditions. The

reset conditions are shown on page 71.

This command does not affect the GPIB settings or stored states.

Note If RESET is executed over the remote interface, interface functions are

not affected (i.e. the 3499A/B/C will stay in Remote mode). If the front

panel RESET key is pressed, interface functions are reset.

OUTPUT 709; “RESET”