Specifications

E: SYStem MENU

1: RDGS STOREØ2: SAVED RDGS Ø3: ERRORØ4: TESTØ5: CHART OUT Ø6: CHART SPANØ

7: CHART NULLØ8: DISPLAYØ9: COMMAØ10: PRESETØ11: REVISION

1: RDGS STORE Enables or disables reading memory.

2: SAVED RDGS Recalls readings stored in memory (up to 1024 readings).

3: ERROR Retrieves errors from the error queue (up to 20 errors).

4: TEST Performs a complete self-test or individual self-tests.

5: CHART OUT Enables or disables the chart recorder output (Analog Out).

6: CHART SPAN Sets the chart recorder output range (Analog Out).

7: CHART NULL Sets the chart recorder output offset (Analog Out).

8: DISPLAY Enables or disables the front panel display.

9: COMMA Enables or disables a comma separator between digits in the display.

10: PRESET Returns the meter to factory default settings.

11: REVISION Displays the meter’s firmware revision code.

F: Input / Output MENU

1: HPIB ADDR Ø 2: INTERFACE Ø 3: BAUD RATE Ø 4: PARITY Ø 5: LANGUAGE

1: HP-IB ADDRSets the GPIB bus address (0 to 30, default 22).

2: INTERFACESelects either the GPIB or RS-232 remote interface.

3: BAUD RATE Sets the baud rate for RS-232 operation.

4: PARITY Selects even, odd, or no parity for RS-232 operation.

5: LANGUAGE Selects interface language, either SCPI or Keithley 181.

G: CALibration MENU *

1: SECURED Ø [1: UNSECURED] Ø [2:CALIBRATE] Ø [3: CHART ZERO] Ø [4 : CHART GAIN] Ø

[5: INJECTED I]

Ø6:CAL COUNT Ø 7:MESSAGE

1: SECURED The meter is secured against calibration; enter code to unsecure.

1: UNSECURED The meter is unsecured for calibration; enter code to secure.

2: CALIBRATE Performs a calibration of meter; must be UNSECURED.

3: CHART ZERO Performs a calibration of the chart recorder output zero level.

4: CHART GAIN Performs a calibration of the chart recorder output gain.

5: INJECTED I Performs a calibration to minimize the injected current.

6: CAL COUNT Reads the total number of times the meter has been calibrated.

7: MESSAGE Reads the first 11 characters of a calibration string, if any,

entered from the remote interface.

* The commands enclosed in square brackets ( [ ] ) are "hidden" unless the meter is UNSECURED for calibration.

Chapter 2 Front-Panel Operation

Front-Panel Menu Reference