User`s guide

Using the MEASure? Command
The following command shows how to use the MEASure? command to make a
measurement. This example configures the instrument for dc voltage
measurements, internally triggers the instrument to take a reading, and then
transfers the reading to the instrument output buffer. The default range
(autorange) and resolution (1 PLC) are used for the measurement.
MEAS:VOLT:DC?
Typical Response: +4.23450000E-03
The following command configures the instrument for 2-wire resistance
measurements, triggers the meter to take a reading, and then transfers the
reading to the instrument output buffer. The 1 kΩ range is selected with 0.1 Ω
resolution.
MEAS:RES? 1000,0.1
Typical Response: +3.27150000E+02