User`s guide

Default Settings for the MEASure? Command
With the MEASure? command, you can select the function, range, and
resolution all in one command. All other measurement parameters are set to
their default values as shown below.
Measurement
Parameter:
CONFigure Setting:
AC Filter 20 Hz (medium filter)
Autozero
OFF if resolution setting results in NPLC <
1
ON if resolution setting results in NPLC ≥
1
Input Impedance
OFF (fixed at 10 MΩ for all dc voltage
ranges)
Offset Compensation
OFF (for 2-wire and 4-wire resistance
measurements)
Samples per Trigger 1 sample
Sample Source AUTO
Trigger Count 1 trigger
Trigger Delay Automatic delay
Trigger Source Immediate
Trig Slope NEG
Math Functions OFF
Null State OFF
The AC Filter, Autozero, and Null State parameters can be set
individually for each applicable measurement function. However, in
each case, the defaults are as listed in the table above. Input
Impedance applies only to dc voltage measurements.