User`s guide

Description
First, this command resets all continuity measurement parameters and
trigger parameters to their default values. Then, it configures the meter for
continuity measurements but does not initiate a measurement. Continuity is
a special type of fixed-range 2-wire resistance measurement.
This command presets the meter to a fixed range and resolution, and then
configures for continuity tests. However, it does not initiate the test.
The CONFigure command does not place the instrument in the "wait-for-
trigger" state. Use the INITiate or READ? command in conjunction with
CONFigure to place the instrument in the "wait-for-trigger" state.