User`s guide

Calibration Errors
The following errors indicate failures that may occur during a calibration. Refer
to the Agilent 34410A/11A/L4411A Service Guide for more information.
701, "Calibration error; security defeated by hardware jumper"
702, "Calibration error; calibration memory is secured"
703, "Calibration error; secure code provided was invalid"
704, "Calibration error: secure code too long"
705, "Calibration error; calibration aborted"
706, "Calibration error: value out of range"
707, "Calibration error: signal measurement out of range"
708, "Calibration error: signal frequency out of range"
709, "Calibration error: no cal for this function or range"
710, "Calibration error: full scale correction out of range"
711, "Calibration error: ADC calibration failed"
720, "Calibration error: DCV offset out of range"
721, "Calibration error: DCI offset out of range"
722, "Calibration error: RES offset out of range"
726, "Calibration error: ACV offset out of range"
727, "Calibration error: ACI offset out of range"
730, "Calibration error: precharge DAC convergence failed"
731, "Calibration error: A/D turnover correction out of range"
732, "Calibration error: AC flatness DAC convergence failed"
733, "Calibration error: AC low frequency convergence failed"
734, "Calibration error: AC low frequency correction out of range"
747, "Calibration variable does not exist"
748, "Cal: mainframe cal memory write failure"