Specifications

TRIGger Subsystem
TRIGger[1|2][:IMMediate]
Agilent E4418B/E4419B Programming Guide 12-11
TRIGger[1|2][:IMMediate]
This command causes a trigger to occur immediately, provided the
specified channel is in the “wait-for-trigger” state. When this command is
executed, the measurement result is stored in the power meter’s memory.
Use FETCh? to place the measurement result in the output buffer.
TRIGger[1|2]:DELay:AUTO is ignored if TRIGger[1|2][:IMMediate]
is set to ON.
Syntax
Example
Error Messages
If the power meter is not in the “wait-for-trigger” state, then
TRIGger:IMMediate causes error -211, “Trigger ignored”.
TRIG This command causes a channel A
trigger to occur immediately.
TRIG
1
2
:IMM
prog.book Page 11 Thursday, June 7, 2001 2:55 PM