Specifications

SENSe Subsystem

[SENSe[1]]|SENSe2:CORRection:CFACtor|GAIN[1|2][:INPut][:MAGNitude]

9-28 Agilent E4418B/E4419B Programming Guide

Query

[SENSe[1]]|SENSe2:CORRection:CFACtor|GAIN[1|2][:INPut][:MAGNitude]? [MIN|MAX]

The query returns the current setting of the gain correction or the values

associated with MIN and MAX.

If [SENSe[1]]|SENSe2:CORRection:LOSS2 is used to set a gain level,

the result of this query is when the default unit is linear, and

when the default unit is logarithmic.

Query Example

Error Messages

If a channel offset value is entered using

[SENSe[1]]|SENSe2:CORRection:GAIN2 while

[SENSe[1]]|SENSe2:SPEed is set to 200, the error -221, “Settings

Conflict” occurs. However, the channel offset value is set but the

[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe command is not

automatically set ON.

The SENSe[1]]|SENSe2:CORRection:CFACtor|GAIN1 command can

be used for the Agilent 8480 series power sensors when no sensor

calibration table has been set up. If a sensor calibration table is selected

the error -221, “Settings Conflict” occurs.

CORR:GAIN1? This command queries the current

setting of the calibration factor on

channel A.

Loss2

-------- ---------

Loss2–

prog.book Page 28 Thursday, June 7, 2001 2:55 PM