Specifications

SENSe Subsystem
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3[:INPut][:MAGNitude]
9-22 Agilent E4418B/E4419B Programming Guide
Query Example
Error Messages
If a duty cycle value is entered using
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error -221, “Settings
Conflict” occurs. However, the duty cycle value is set but the
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe command is
not automatically set ON.
If this command is used when an Agilent E-series power sensor is
connected, the error -310, “System error;Dty Cyc may impair accuracy
with ECP sensor” occurs. If you are using the Agilent E4419B the error
message specifies the channel.
CORR:GAIN3? This command queries the current
setting of the duty cycle for
channel A.
prog.book Page 22 Thursday, June 7, 2001 2:55 PM